These are some of the Petter brass spec. plates that I have produced. If you do not see the plate you are looking for please contact me - I may be able to supply it or you could send me a GOOD, CLEAR, HIGH RESOLUTION PHOTOGRAPH to copy.

Please note:
    i) Check sizes show in the pictures - if these do not tally with yours be sure to let me know. Sizes can be changed BEFORE production but mistakes cannot be rectified later!

    ii) Some measurements may be shown to 2 decimal places - I DO NOT work to these tolerances, these plates are ground to final size by hand on a disk linisher and sizes DO vary slightly. I also only work with metric sizes - feel free to convert them to "inch" measurements yourself.

    iii) Holes or hole centres are usually also shown on the pictures but I do not drill these.

    iv) Scratches seen on the photographs of finished plates are how they are supplied. These are from the steel wool that I use to clean the etch mask off with and disappear as soon as they are polished or buffed which I leave to the buyer.
   
    v) Although pictures are usually shown with painted backgrounds I do not supply them painted. They are supplied as plain brass plates.

    vi) Serial Numbers shown are for illustration only. I can either leave this blank or you can supply your number. These will be etched in - not stamped.

Click here to go to my main "Plates" page which has more information regarding ordering plates.

When ordering please quote the description at the bottom and to the right of each picture.